How is the right way to play the flute
First, the flute hole flat, the air flow feels like 90 degrees into the hole, to get full friction, to make the sound clear, bright, clean and round. When playing the flute, too looking up or down will also change the angle of the airflow. When the upper and lower lip is pressed on pressure, overflow the lower lip outward, just 1 / 2 of the cover hole, (the lower lip should preferably not exceed 1 / 2 of the blow hole). When blowing, the middle vent of the lips shall be olive shaped with the size of approximately 5 - 6 mm in length and must not exceed the length of the blow hole. When playing the bass, it can be slightly larger. Due to the bass, both sides of the outlet shall be controlled. When playing the high tone, the mouth wind can not overflow, keep the breath concentrated, have the feeling of gathering at a point. The upper lip should be blown beyond the lower lip, but not too much of the front and back of the upper lip will directly change the direction and angle of the air flow (Figure I and 2). Special attention should be paid to the outlet part of the upper and lower lips, not tight pressure, should let the air flow blow out without obstruction. At this time the whole lip muscle is in a squeezed state, should be slightly raised forward, make the flow very concentrated into the flute hole. This allows the flute.